- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
Variable arrays in FEKO 5.4
录入:edatop.com 点击:
Hello everyone,
Does anyone know how to create variable arrays in FEKO? For the life of me I can't figure it out or find any documentation.
The application is to create a single array of lengths for a Yagi antenna. that way, when I want to tune the lengths, I can address the entire array (like in MATLAB) and add a certain percentage. Right now, I have a model but each length is its own variable, which is very cumbersome and time consuming.
Also, extra points to anyone who can tell me how to do a parameter sweep (not an optimization)!
Thanks!
Does anyone know how to create variable arrays in FEKO? For the life of me I can't figure it out or find any documentation.
The application is to create a single array of lengths for a Yagi antenna. that way, when I want to tune the lengths, I can address the entire array (like in MATLAB) and add a certain percentage. Right now, I have a model but each length is its own variable, which is very cumbersome and time consuming.
Also, extra points to anyone who can tell me how to do a parameter sweep (not an optimization)!
Thanks!
Perhaps variable arrays aren't possible in CADFEKO?
if you design array antenna you cannot create variable for array number
---------- Post added at 09:52 ---------- Previous post was at 09:50 ----------
but if you design array antenna you can create with for command