- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
How to calculate the Noise Figure in CST MW Office?
录入：edatop.com 点击：
Hi everybody.
I just made a 3 section chebyshev transformer into a rectangular waveguide. So far, so good, let's say I reach the specifications, and let's say it it coupled.
So, anyone of you knows how to calculate the noise figure with CST Microwave Office?
I think I have to program it.... but how? Maybe as a Post-process, with the S parameters. I don't know. Do you?
I just made a 3 section chebyshev transformer into a rectangular waveguide. So far, so good, let's say I reach the specifications, and let's say it it coupled.
So, anyone of you knows how to calculate the noise figure with CST Microwave Office?
I think I have to program it.... but how? Maybe as a Post-process, with the S parameters. I don't know. Do you?
Hi ardiware
refer this for your information
http://xmujpkc.xmu.edu.cn/dccywbjssy...ingStarted.pdf
also see the following post
https://www.edaboard.com/ftopic240777.html
You will get amplifier tutorials
where you will find how to measure NF in MWO.
ardiware,
CST Microwave Studio or AWR MWO ?
Oh yes... he he... sorry, I mixup the two softwares.
It it CST Microwave STUDIO.
And thanks for the help, Abhi~, that PDf will be helpful too, but I need to measure the noise figure in the CST MW Studio.
