- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > FEKO天线仿真 > FEKO仿真讨论 > Is there any way to modify or change the output file of Feko then reverse it and run
Is there any way to modify or change the output file of Feko then reverse it and run
录入：edatop.com 点击：
Hi guys
Could you please tell me is there any such method to do some reverse design using Feko. I mean can we modify any of the output file such as .out, .cfm or .pfs files so we can make a change on our original design then re run it again?. I need this specific technique to make a fine tuning on my structure by removing some part of the meshed segment.
thannk you in advanced
Could you please tell me is there any such method to do some reverse design using Feko. I mean can we modify any of the output file such as .out, .cfm or .pfs files so we can make a change on our original design then re run it again?. I need this specific technique to make a fine tuning on my structure by removing some part of the meshed segment.
thannk you in advanced
CST微波工作室培训课程套装，专家讲解，视频教学，帮助您快速学习掌握CST设计应用
上一篇：Feko Error 85： Singular Field on the edge of a triangle
下一篇：Problem about calculating the eigenvalue using the output impedance matrix from FEKO
