Designing Coupled-Line Balun to feed printed-dipole antenna

Hi,

I want to design a coupled-line balun to feed my printed-dipole antenna. The balun is required to support only odd-mode and suppress even mode in order to feed my dipole antenna.The input impedance of my dipole antenna is 34 Ohm.

I am trying to design coupled-line balun using ADS. The schematic is attached here. Please guide me whether my attached schematic is correct and what S-parameters do I need to optimize in order to support odd-mode and suppress even mode?

Regards,

Abdul
Ohio State University

附图/附件

Feed_for_printed_dipole_wrk.rar

Anyone knows about coupled-line balun design in ADS? Help needed, please.

Use CLIN component.

Refer this site

http://www.microwaves101.com/encyclopedias/baluns

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。