ads2012在win7 64位下无法仿真

今天装了ads2012.8，能启动，能建电路模型，就是在运行仿真时出现问题：（看到网上很多人都说能运行成功，哎我的问题就这么多呢。）
Simulation Messages
Error detected by hpeesofsim during circuit set up `SP1'.
    An appropriate license for linear features is not available. This
    feature must be licensed before it can be used.
     FlexLM error message:
     RF System Simulator
     Cannot connect to license server
     Possible Causes:
     1. The connection attempt to the vendor daemon on all SERVER nodes was unsuccessful.
     2. The license server has not been started yet.
     3. The software is pointing to the wrong license server or "port@host" specification.
     4. The network is down or a firewall is blocking communication.
     5. A node-locked license was configured on a license server not intended for remote use.
     Troubleshooting Tips:
     1. Make sure your software is pointing to the correct license server.
     2. Verify that the license server is running on the networked machine.
     3. Try a different license server if available.
     4. Specify a port outside of the default range (27000-27009) on the SERVER line in the license file.
     5. Set a unique port number on the VENDOR line and configure the firewall to have this port open.
     6. Contact your system administrator to ensure the port numbers being used are available.
     7. Temporarily disable your firewall and try to re-connect to the license server system.
     8. Consult your license administrator to verify that the license server is running a floating license.
     License Requested: b_comms_verification
     License path: D:ADS2012_08license.lic

网友回复:

解决了，我是双网卡，无线网卡 的id我也 添加进去了，所以不能仿真只能添加一个网卡id

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。