CST2013: Polygon Creation Mode

Modeling: CurvesPolygon

In this mode, you may interactively define a polygon (either open or closed) by double-clicking its points in the currently active coordinate system.

You may change the view at any time by using the standard view changing options.

Creation steps

When you first enter the mode, you will be asked to double-click to mark the first point of the polygon. The cursor’s location will be projected onto the currently active working plane to define the point (always remember to release the mouse button after double-clicking, before dragging to the next point).

After a point has been set, you may specify the next point by again double-clicking at a location on the working plane. During this operation, a rubber-band polygon will be displayed indicating the current shape of the polygon.

In the case that a new point coincides with the first polygon point, the interactive mode is automatically terminated. Otherwise, the mode may be terminated by double-setting (twice double-clicking) a point or by pressing the ESC key.

After the polygon mode is finished, a polygon dialog box appears where you may check your settings and specify a name and a curve for the new polygon.

SHIFT key

By pressing the SHIFT key after the first point has been set, the cursor movement is fixed in one coordinate and may only be moved in the other and vice versa.

Display of locations

Throughout this mode the current mouse location will be displayed in the lower right corner of the main plot window .

Snap mode

All positions will be adjusted to the snap grid when active.

Cancel interactive mode

You may cancel this mode at any time by pressing the ESC key. Pressing ESC again in the following dialog box will terminate the polygon creation.

Undo last double-click

You may go back to the last step by pressing the BACKSPACE key. Pressing this key in the interactive mode will undo the last double-click.

Numerical specification of coordinates (TAB key and SHIFT+TAB key)

To precisely specify the shape coordinates, you may press the TAB key whenever a point must be double-clicked. A small coordinate dialog box will open in which you may manually specify the shape coordinates.

The dialog entries take over the coordinates at the cursor position on the working plane. However if the SHIFT+TAB key is pressed, the coordinates are always set to zero.

Pick tools to specify coordinates

You may snap the location to a previously defined shape’s corner, cylinder radius, etc., by activating a point pick tool, at the moment when the next point must be specified. The double-click will be processed by the pick functionality to specify the location of a point. The picked point will then be taken as the selected location.