• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > CST > CST2013 Help > CST2013: Exclude Port-Modes

CST2013: Exclude Port-Modes

录入:edatop.com     点击:

Post Processing: Signal Post Processing S-Parameter CalculationsExclude Port-Modes...

This dialog makes it possible to choose which port-modes will be considered for post processing or otherwise will be excluded. Port-modes that have been excluded can be regained by switching the status back to not excluded. No additional solver runs are necessary for this issue because it is done as a post processing step.

 

This feature allows to renormalize a subset of S-Parameters if all port-modes that were not previously excited are excluded from post processing. In the same way it is also possible to achieve single-ended S-Parameters even if not the complete S-Matrix was calculated.

 

For ports with the single-ended feature switched on it is only possible to exclude all (or none) of the calculated modes.

 

Port

In this column, the port number identifying the port is displayed.

Mode

The mode patterns for the S-Parameters are listed here.

Status

Displays if the corresponding port-mode is excluded or not excluded.

Toggle Status

Switches  the status display between excluded and not excluded.

OK

Accepts your settings and leaves the dialog box.

Cancel

Closes this dialog box without performing any further action.

Help

Shows this help text.

 

 

 

 

CST微波工作室培训课程套装,专家讲解,视频教学,帮助您快速学习掌握CST设计应用

上一篇:CST2013: Farfield Plot – Origin
下一篇:CST2013: The QuickStart Guide

CST培训课程推荐详情>>

  网站地图